Cisco ATA - Indicators and Ports

Steady green: System booted up successfully and is ready for use.

Slow flashing green: System is booting up.

Fast flashing green three times, then repeats: System failed to boot up.

Fast flashing green: The LED behaviour occurs in the following situations:

• System detects a factory reset.
  To perform a factory reset, press and hold the RESET button for about 10 seconds.
• A factory reset is performed successfully.

Off: Power is off.

Flashing green: Data transmission or reception is in progress through the WAN port.

Off: No network connection detected.

Steady green: On hook.

Slow flashing green: Off hook.

Fast flashing green three times, then repeats: The analog device failed to register.

Fast flashing green: A factory reset is performed successfully.

Off: The port is not configured.

Not used by Nextiva.

Restart or Factory Reset the device.

To restart the ATA, use a paper clip or similar object to press this button briefly.

To restore the factory default settings, press and hold for about 10 seconds.

The LED behaviour for the factory reset:

1. After you press and hold the button for about 10 seconds, the Power LED is fast flashing green.
2. After the factory reset is performed successfully, all LEDs are fast flashing green for about 5 seconds.

RJ-11 connection for an analog phone

Ethernet port to connect your ATA to a device on your network, such as a computer.

Ethernet port to connect your ATA to your network

Power port for device.